Nederlands
Contact
Sitemap
Search
OrganisationEEMCS EPrints Service
 |
|
|
||||||||||||||||||||||||||||||||||||
|
|
|
|
|
||||||||||||||||||||||||||||||||||
|
|
|
||||||||||||||||||||||||||||||||||||
|
|
|
|
|
||||||||||||||||||||||||||||||||||
|
|
Tiggelaar, R.M. and Berenschot, J.W. and de Boer, J.H. and Sanders, R.G.P. and Gardeniers, J.G.E. and Oosterbroek, R.E. and van den Berg, A. and Elwenspoek, M.C.
(2005)
Fabrication and characterization of high-temperature microreactors with thin film heater and sensor patterns in silicon nitride tubes.
Lab on a chip, 5.
pp. 326-336.
ISSN 1473-0197
*** ISI Impact 6,260 ***
Full text available as:
Official URL: http://dx.doi.org/10.1039/b414857f  AbstractIn this paper the fabrication and electrical characterization of a silicon microreactor for high-temperature catalytic gas phase reactions, like Rh-catalyzed catalytic partial oxidation of methane into synthesis gas, is presented. The microreactor, realized with micromachining technologies, contains silicon nitride tubes that are suspended in a flow channel. These tubes contain metal thin films that heat the gas mixture in the channel and sense its temperature. The metal patterns are defined by using the channel geometry as a shadow mask. Furthermore, a new method to obtain Pt thin films with good adhesive properties, also at elevated temperatures, without adhesion metal is implemented in the fabrication process. Based on different experiments, it is concluded that the electrical behaviour at high temperatures of Pt thin films without adhesion layer is better than that of Pt/Ta films. Furthermore, it is found that the temperature coefficient of resistance (TCR) and the resistivity of the thin films are stable for up to tens of hours when the temperature-range during operation of the microreactor is below the so-called burn-in temperature. Experiments showed that the presented suspended-tube microreactors with heaters and temperature sensors of Pt thin films can be operated safely and in a stable way at temperatures up to 700 °C for over 20 h. This type of microreactor solves the electrical breakdown problem that was previously reported by us in flat-membrane microreactors that were operated at temperatures above 600 °C.
Export this item as: To correct this item please ask your editor Repository Staff Only: edit this item |
|
|
||||||||||||||||||||||||||||||||||
|
|
|
||||||||||||||||||||||||||||||||||||
|
|
|
|
|
||||||||||||||||||||||||||||||||||
|
|
|
||||||||||||||||||||||||||||||||||||
