Nederlands
Contact
Sitemap
Search
OrganisationEEMCS EPrints Service
 |
|
|
||||||||||||||||||||||||||||||||||||
|
|
|
|
|
||||||||||||||||||||||||||||||||||
|
|
|
||||||||||||||||||||||||||||||||||||
|
|
|
|
|
||||||||||||||||||||||||||||||||||
|
|
Deladi, S. and Berenschot, J.W. and de Boer, M.J. and Krijnen, G.J.M. and Tas, N.R. and Elwenspoek, M.C.
(2005)
In situ characterization technique for nanotribological investigations.
Review of scientific instruments, 76.
pp. 016102-016104.
ISSN 0034-6748
*** ISI Impact 1,598 ***
Full text available as:
Official URL: http://dx.doi.org/10.1063/1.1834712  AbstractAn innovative technique has been developed to enable in situ monitoring of mechanical surface modification. The method is based on using a test surface and a sharp tip located on two different cantilevers; one for mechanical surface modification and the other for in situ detection of surface topography change. The device can be used in standard atomic force microscope, the image obtained during scanning contains information about a partly modified and a partly unmodified topography for each scanning line, thus quantification of surface topography modification (e.g., wear) or the change of different parameters (e.g., friction force) can be followed as it occurs. The characterization technique and typical results are presented.
Export this item as: To correct this item please ask your editor Repository Staff Only: edit this item |
|
|
||||||||||||||||||||||||||||||||||
|
|
|
||||||||||||||||||||||||||||||||||||
|
|
|
|
|
||||||||||||||||||||||||||||||||||
|
|
|
||||||||||||||||||||||||||||||||||||
